Cod Liver Rendering Plant
Stock #RG9689
Used Liver Rendering plant consisting of Liver tank size is 5,3 m³, Hooks filter, grinder M-1, magnet for hooks and feeding pump D-1. 15m² heat exchanger (Tube/shell) with regulating valve L-1 for steam, pressure sensor at the inlet P-1 and thermometer on the outlet T-1 to regulate the steam agenst the outcoming heat of the liver. Process tank 1 size 1000 Ltr, pump D-2 and Steam cooker with regulating valve L-2 and thermometer to regulate the steam agenst the outcoming heat of the liver. Decanter M-2, process tank size 220 Ltr and feed pump D-3. Two centrifuges, tank and pump for residue from centrifuge and pump D-4 for clean oil from separators to day tanks. Two day tanks for oil from separator size 6800 Ltr each, pump D-6 for pumping oil to storage. All electrical devices and PLC control are in one cabinet, PLC is Allan Bradley with a shreen on the door of the cabinet. All pumps have frequecy controller. This plant can process 1-2 tone/hour of liver.
Location: ICELAND
Add to Cart
View Details
Anco Blood Coagulation and Dewatering System
Stock #ZG62289
Blood dewatering system. Rated for up to 5-7 gpm (1000-1500 liter/hour)
ANCO 305 Blood Coagulation and Dewatering System
- Design capacity: 1000-1500 liter/hour of fresh whole blood
- Heavy duty stainless steel construction
- Designed to allow for solids (i.e. chicken heads)
- Vertical design (for minimum space requirements)
- Process piping connection
- Low HP design (2.5 HP)
- Reduces moisture of properly coagulated blood to 65-70%
- Includes stainless steel vapor connection for reduced plant emissions
ANCO Blood System PLC and Valve Package
- Low voltage panel with PLC and HMI to allow the system to run in "auto" mode
- Temperature control system and thermocouples
- Steam pilot pressure regulator valve
- ANCO steam feed manual valve package and miscellaneous gauges and indicators
ANCO 228 Blood Pump
- Positive displacement blood metering pump
- Chrome plated alloy steel rotor
- 3" inlet, 2-1/2" outlet
- Capacity: 2 gallon; 25 gallon maximum
- 2 HP (VFD by client) TEFC drive
- Blood pump with base.
Project Services & scope of Supply:
A.) Design and drafting related to the attached drawing list.
B.) Project management for the equipment design and layout.
C.) Equipment procurement.
D.) Two (2) sets of operation and maintenance manuals.
E.) Electrical equipment specifications for equipment supplied by ANCO.
F.) General drawing package to include one or more of the following drawings:
* Electrical Layout, Power Wiring, Control Panel and Control Wiring.
* Elevations, Roof and Wall Openings.
* Process Flow Analysis for ANCO supplied equipment only.
* Sections & Details as required.
* Foundation layouts; suggested placement of ANCO supplied equipment.
Location: N/A
Add to Cart
View Details
20,000 lb. per Hour Haarslev HF400 Grinder
Stock #ZG59944
Used Haarslev Model HF400 grinder. Hopper fed, single knife set. Feed screw driven by V-belt and planetary gearbox with 150 HP motor, TEFC, 480 vac, 60 HZ. Built 2007. Capacity of approximately 20,000 lbs/hour. 60" wide X 108" deep X 84" high.
Location: Midwest USA
Add to Cart
View Details